Snap-In Valve Stem Installation Procedures

We get a lot emails and calls from customers asking us how to properly install a Snap-In valve stem after dismounting the rim and removing the tire. Avoid installation headaches. We're here to solve your TPMS problems and make the Snap-in valve stem install procedure simple and easy.

1) Remove the t-10 screw using the Schrader t-10 torque tool.

2) Remove the valve with the valve puller. never reuse removed or used valves

3) Lubricate the new valve.

4) Insert new snap-in valve in valve hole.

5) Use the rubber block and the valve puller to pull the snap-in valve through the valve hole, ensuring a consistent angle with the valve hole.

6) Put the tire on the rim, making sure the traction point is infront of the sensor.

7) Perform RIST: Remove, Inspect Snug Torque of the wheel and rim prior to remounting the tire on the vehicle.

8) Mount the tire on vehicle.

That's it! If you have any questions, please feel free to email us at [email protected] or give us a call at (714) 482-3996.